Using The Heater - HOMCOM 820-317V90 Manual De Instrucciones

ASSEMBLING
Aiming the base to the unit body and fixing the base with 4 screws.

USING THE HEATER

1. Before inserting the plug into an electrical outlet, make sure that the electrical
supply in your area matches that on the rating label on the unit.
2. When plugged in, turn on the Main power switch at the base side of unit.
3. When in Standby mode, only
Press to access the rest of the control panel.
a)Low Power: (Press
b)High Power: (Press
c)Timer: Press
(between 0 hour to 12 hours)
d)+ , - : adjust room temperature .Temperature setting from 10-35 degree. "+" to
increase the desired temperature and "-" to decrease the desired temperature
e)
f)Swing : Press
f) , turn on or turn off item . item always keep working 30 seconds of cool air after
turn off it . this design can protect item use longer.
Warning:
1.Before removing the plug from the socket, switching off and better work for 30-60
second for cool down in condition that protecting inner parts.
Remote control
Please use Lithium battery CR2025 3V.
NOTE: the remote control buttons perform the same functions as those on the control
panel on the unit.
on the control panel will respond to your touch.
to switch it)
to switch it)
repeatedly to set a period after which the heater will turn itself off
to activate oscillation. Press it again to cancel.
3