Skil CR5440B-00 Manual Del Propietário página 17

LED Light (Fig . 8)
Your tool is equipped with an LED light located
under the auxiliary handle. This provides
additional light on the saw blade and the
surface of the workpiece for operation in lower
light areas.
The LED light will automatically turn on with a
slight squeeze of the trigger switch before the
tool starts running. It will turn off approximately
10 seconds after the trigger switch is released.
The LED light will rapidly flash when the tool
and/or battery pack becomes overloaded or too
hot and the internal sensors will turn the tool
off. Rest the tool for a while or place the tool
and battery pack separately under air flow for
cooling.
The LED light will flash more slowly to indicate that the battery pack is at low-battery capacity.
Recharge the battery pack.
Vacuum Hose Port (Fig . 9)
Your saw is shipped with a vacuum hose port
and an M4 Phillips head screw to attach the
hose port to the saw. The hose port accepts
vacuum/dust extractor hoses with
Ø1-1/4" (32mm).
a. Remove the battery pack.
b. Attach the vacuum hose port to the saw
using the M4 Phillips head screw provided.
c. Attach a suitable vacuum extractor hose or
use an adapter, if necessary.
d. Disconnect the vacuum hose when finished
cutting.
WARNING
operation.
Never allow a vacuum/
dust extractor hose to interfere with the lower guard or cutting
Fig. 8
LED Light
Fig. 9
Ø1-1/4"
(32mm)
Vacuum
Hose Port
17