Operating Instructions - Skil CR5440B-00 Manual Del Propietário

WARNING
f. Reinstall the outer washer. First tighten the blade bolt finger tight, then tighten the blade bolt
1/8 turn (45°) with the hex key (this ensures slippage of the saw blade when it encounters
excessive resistance, thus reducing motor overload and saw kickback).
Insert the hex key back into its storage area on the circular saw.
g.
Fig. 3
Tighten
Loosen
Hex key

OPERATING INSTRUCTIONS

WARNING
fluid or allow a fluid to flow inside them.
certain industrial chemicals, bleach or bleach-containing products, etc. can cause a short
circuit.
WARNING
parts could result in serious personal injury.
WARNING
is misuse and could result in a hazardous condition leading to possible serious injury.
WARNING
This cordless circular saw must be used only with the battery packs and chargers listed
below:
2Ah 2Ah
SKIL SKIL
BY519701 BY519702
14
Make sure that the clamping surfaces of the inner and outer washers
are perfectly clean and face the blade.
Outer Washer
(Large diameter faces blade)
Blade Bolt
To reduce the risk of fire, personal injury, and product damage due to
a short circuit, never immerse your tool, battery pack, or charger in
If any parts are damaged or missing, do not operate this product until
the parts are replaced.
Do not attempt to modify this tool or create accessories not
recommended for use with this tool.
To prevent accidental starting that could cause serious personal injury,
always remove the battery pack from the tool when assembling parts.
Battery Pack
2.5Ah
SKIL
BY519703
Blade Shaft
(Large diameter faces blade)
Corrosive or conductive fluids, such as seawater,
Use of this product with damaged or missing
4Ah 5Ah
SKIL SKIL
BY519601 BY519603
Spindle Lock
Button
Inner Washer
Blade
Any such alteration or modification
Charger
SKIL
SC535801
SKIL
QC5359B-02
SKIL
QC536001
SKIL
SC5358B-02