Troubleshooting - Skil CR5440B-00 Manual Del Propietário

TROUBLESHOOTING

Problem
Tool does not start.
Blade does not come up to
speed.
Excessive vibration.
The blade does not follow a
straight line.
Cut binds, burns, stalls
motor when ripping.
Blade slipping.
22
Cause
1. Battery pack charge is
depleted.
2. Battery pack is not
installed properly.
3. Burned out switch.
1. Low battery charge.
1. Blade out of balance.
2. Workpiece not clamped or
supported properly.
1. Blade teeth are dull.
2. Foot is out of line or bent.
3. Blade is bent.
1. Dull blade with improper
tooth set.
2. Blade binds.
3. Improper workpiece
support.
1. Tool does not cut
workpiece.
Remedy
1. Charge the battery pack.
2. Confirm that the battery is
locked and secured to the
tool.
3. Have the switch replaced
by an Authorized SKIL
Service Center or Service
Station.
1. Recharge the battery pack
or use a fully charged pack.
1. Discard blade and use a
different blade.
2. Clamp or support workpiece
properly according to this
manual.
1. Replace the blade with a
new one.
2. Have the tool repaired by
an Authorized SKIL Service
Center or Service Station.
3. Replace the blade with a
new one.
1. Discard blade and use a
different blade.
2. Reassemble the blade
and tighten the blade bolt
according to this manual.
3. Clamp or support workpiece
properly according to this
manual.
1. Reassemble the blade and
tighten the blade bolt to this
manual.