Setting The Time Groups - VDO MTCO 1324 Instrucciones De Servicio

8. a) Push the blocked drawer in until it
latches.
b) Bring the hinged drawer into a hori-
zontal position and push it in until it
latches.
9. The basic display is shown:
including date, time, and the total
number of kilometres,
additionally, the symbols for the
inserted charts, and current position
of the time groups, on the left for
driver 1 and on the right for driver 2
are displayed.
Notes on the basic display
• The time of the MTCO 1324 is adjusted
to the legal time of the country where the
vehicle has been registered. The start
and the end of the daylight saving time
are deposited within the device and will
be updated automatically.
page 33 "Error code - overview".
• In case an exclamation mark appears
next to the total kilometre reading, there
has been a failure.
"Error code - overview".
• Option: digital v-display
Depending on the design, the vehicle
speed display may be shown in the
1st line. Otherwise all functions are anal-
ogous to the basic display.
28
See also
See also page 33

Setting the time groups

2 driver operation
10. Driver 1 presses the
Press the key several times, until
the desired time group is shown in
the display.
Driver 2 presses the
Press the key several times, until
the desired time group is shown in
the display.
As soon as the vehicle starts to drive, there
will be an automatic display of the basic
display
• for the driver 1 "
• for the driver 2 "
1 driver operation
• Only insert the chart for driver 1 on the
separating plate during 1 driver oper-
ation.
• Set the time group for driver 2 in any
case to break time "
will be an error message.
Time group distribution
= driving times
= remaining working times
= availability
(waiting times, co-driver times, times
in sleeping cabin during ride)
= break times and restoring periods
key.
key.
" and
".
" otherwise there
Kienzle MTCO 1324