Trouble Shooting; Updating The Chart Carrier - VDO MTCO 1324 Instrucciones De Servicio

Displayed messages

Trouble shooting

Only after having remedied the error cause,
e.g. in case of an operating error, will the
message automatically be deleted.
In case one of the messages is
shown repeatedly, immediately
consult a VDO service partner!
34
Code Meaning / measure
= Error in recording system
(The MTCO 1324 will record these errors on the
chart,
= Error at "B7" v-pulse output
= Disconnection towards indicating instrument
= Error during pulse generator communication
= Error in pulse generator key / serial number /
signal
(The MTCO 1324 will record these errors on the
chart,
= Power loss
(Error code cannot be found in the error memory.
The MTCO 1324 will record a power loss on the
chart,
see page 39.)
see page 39.)
see page 39.)

Updating the chart carrier

1. Open the drawer and remove both
charts.
2. Close the drawer again.
The MTCO 1324 will automatically
update the time of the chart carrier,
and the error symbol and the time will
then stop to flash.
3. Open the drawer and insert new charts
if necessary. The MTCO 1324 will be
ready for use again.
Kienzle MTCO 1324