Troubleshooting - Cuisinart FCC-2 Serie Manual De Instrucciones

TROUBLESHOOTING

Problem
Coffee Mode is not working
Coffee Brew Time not on
No lights are on
Water is not heating up
Keep Warm function is
not working
Goes into standby mode instead
of remembering settings when
kettle is back on base
"Err" is displayed on the LED and
all the lights are flashing
Water is taking longer than
usual to heat"
Pressed the wrong button
If the coffee mode is not enabled, the filter basket is not
installed properly. Be sure the coffee basket locks in place
and basket knob aligns with arrow on handle.
Be sure to press the
ature selection. If you are pressing the Power Button and
kettle is still not heating, call our toll-free Consumer Service
Center at 1-800-726-0190.
Be sure the unit is plugged in and the kettle is securely on
the power base. Then use the control panel to make your
temperature selection and press the
Be sure to press the Power Button after pressing your
temperature selection. If you are pressing the
and kettle is still not heating, call Cuisinart Customer
Service.
The Keep Warm function is the default setting. The icon on
LED Display indicates whether it is on or off. To activate/
deactivate the 30-minute Keep Warm feature, press and
hold the Brew Strength Button for 3 seconds.
If the kettle is off the base for more than 2 minutes, the
internal memory turns off. Simply put it back on the base,
reselect your settings and press the
The water level in the glass kettle is too low for heating.
To avoid damaging the heating element, remove the kettle
from base, add water, return it to the base and press the
Button again.
Several variables can affect heat-up time, including room
temperature, how much water is in the glass kettle, and the
temperature of the water. If you've recently heated water to
a higher temperature than your current selection, the kettle
will appear to be heating, but is actually waiting for water to
cool down. Add cold water to speed up the process.
Change your selection at any time by simply pressing
the temperature selection button. When the LED stops
flashing, the selected temperature has been reached.
10
Solution
Button after pressing your temper-
Button.
Button.
Button