Memory Feature; Boil-Dry Protection; Cleaning And Maintenance - Cuisinart FCC-2 Serie Manual De Instrucciones

MEMORY FEATURE

The appliance features an internal "memory"
that lets you leave the kettle off the base for
up to 2 minutes without it going into standby
mode. When returned to the base, it will
resume the heating and/or Keep Warm cycles
right where they left off.
Note: If appliance goes into standby mode
before it's returned to base, simply reselect
your preset temperature and press
it back on.

BOIL-DRY PROTECTION

1. This appliance is equipped with boil-dry
protection. If it starts heating without
enough water in the unit, the heater will
automatically shut off to avoid damaging the
heating element. Once the kettle has cooled
down, lift it off the base, then replace it to
reset and restart the heating cycle.
2. The quickest way to cool down the heater is
to fill the kettle with cold water; however,
you can also wait for it to cool down by
itself.
CHANGE OF TEMPERATURE
SETTING
The temperature of this unit can be changed
from Fahrenheit to Celsius. Press the
Temperature Control ( ) for more than
3 seconds. The temperature is factory preset
at Fahrenheit.
CLEANING AND
MAINTENANCE
Always turn this appliance off and remove the
plug from the electrical outlet before cleaning.
Lift up the filter basket lid. Remove and
discard the ground coffee from the coffee filter
basket. The filter basket can be washed in
warm, soapy water and rinsed thoroughly, or
cleaned in the upper rack of the dishwasher.
Dry all parts after use.
Do not put any water in the unit once the
filter basket has been removed. Wipe the
area under the filter basket with a damp
cloth. Remove the kettle from the base.
Discard any remaining coffee. The kettle and
lid can be washed in warm, soapy water and
rinsed thoroughly, or placed in a dishwasher.
The kettle and kettle lid should be placed on
the upper rack only.
Do not use any scouring agents or harsh
cleaners on any part of the coffeemaker.
Never immerse power base in water or other
liquids. To clean base, simply wipe with a
clean, damp cloth and dry before storing.
Fingerprints and other blemishes on the
housing can be washed off with soap and
to turn
water or a nonabrasive cleaning solution.
Wipe base with a clean, damp cloth. Never
use rough, abrasive materials or cleaners to
clean the base.
Do not dry the inside of the kettle with a
cloth, as lint may remain.
Maintenance
Any other servicing should be performed by
an authorized service representative.
9