universalblue UVT1300-20 Manual De Instrucciones página 27

fixture must be able to support the weight of the
moving fan without moving.
 Make sure that at the installation site the blades do
not come into contact with any objects. Always
leave a minimum clearance of 150 mm from the tip
of the blades to the wall or ceiling. Keep in mind that
the larger the space, the better the airflow of the fan.
 Do not use in an open space or where it can be
exposed to water or moisture.
 Do not connect the fan motor to a current regulator.
It could give unsatisfactory performance (engine
buzzing) and cause engine damage.
 This appliance is not intended for use by persons
(including children) with reduced physical, sensory,
or mental capabilities or lack of knowledge, unless
they are receiving
regarding the use of the appliance by a responsible
person. You should check that children do not use
the fan as a toy.
 The fan cannot be started in a room with a gas
appliance running at the same time.
 The fan must be turned off and stopped completely
before reversing the direction of the fan. This will
prevent any damage to the fan motor or controller (if
installed).
 Do not insert any objects into the fan blades while
they are rotating. This can damage them and upset
the balance of the ventilator, even knocking it down.
 After the fan is fully installed, make sure that all
fasteners are secure to prevent the machine from
wobbling or falling.
supervision or instruction
27