universalblue UVT1300-20 Manual De Instrucciones página 38

The 3 cables coming out of the signal receptor (I) (white, black
and blue) must be connected with the cables coming out of the
support rod (E). Once the joint has been made, fix it with the
caps provided, as shown in the image below:
After making the connections between the cables, please
seal the joint with the caps included with this appliance, so
that the different cables do not touch each other with the fleuron or
other components.
Then use the terminal strip on the receiver bracket (G) to insert
the 2 cables coming out from the other side of the signal
receptor (I).
The yellow and green (earth) cable coming out of the receiver
bracket (G) together with the cable of the same colour coming
out of the support rod (E) , must be inserted through the same
38