Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Assembly
Before initial operation of the equipment,
the two-part shaft tube must be assem-
bled, the handle fitted, the cutting device
with protective cover installed, the carrying
strap fitted and the equipment checked.
Fitting the Two-Part Tube
B
C
D
1. Remove the protective transport cap
L
M
N
from the bottom shaft tube (5).
2. Loosen the tube fixing screw (7) on the
top shaft tube (3).
V
W
X
3. Plug the two shaft tubes (3 + 5) into
each other so the safety button (4)
clicks into the notch provided for it in
A
the top shaft tube.
4. Retighten the tube fixing screws (7).
K
Ensure that the bottom shaft tube is
sitting firmly and safely before start-
U
ing the equipment.
5. Dismantling:
Loosen the tube fixing screw (7). Press
the safety button (4) and pull the tubes
A
B
apart
C
D
E
Fitting the Handle
K
L
1. Place the handle without the speed
M
N
O
U
V
control lever (8) on the holder on the
upper shaft tube (3).
W
X
Y
2. Insert the handle with the speed con-
trol lever (8) over this on the holder.
3. Screw the handles with the four Allen
screws supplied to the holder.
E
F
G
O
P
Q
A
B
C
Y
Z
K
L
M
U
V
W
B
C
D
L
M
N
V
W
X
C
D
E
F
G
H
M
N
O
P
Q
R
W
X
Y
Z
Installing/Removing the
Metal Cutting Blade
Wear protective gloves when han-
dling the metal cutting blade.
Dismantling the reel capsule is
H
I
J
described in the section on "Install-
ing/Removing the Reel Capsule".
R
S
T
D
E
F
Installing the protective cover /
metal cutting blade:
1. Screw the protective cover onto
N
O
P
the cutting head holder using the 3
screws enclosed.
X
Y
Z
E
F
G
Installing the metal cutting blade:
2. Place the metal cutting blade (11)
and flanges on the cutting head hold-
O
P
Q
er (11) in the following order:
Bottom flange – metal cutting
Y
Z
blade (11) – top flange.
3. Screw on the metal cutting blade (11)
anticlockwise
nut.
F
G
H
Removing the metal cutting blade:
I
J
4. To lock the axle, push the enclosed
P
Q
R
metal pin sideways into the hole pro-
vided on the cutting head holder and
S
T
Z
on the bottom flange.
5. Unscrew the fixing nut clockwise with
the aid of the maintenance key and
remove the top flange and the metal
cutting blade (11).
G
H
I
Q
R
S
H
I
J
R
S
T
using the fixing
I
J
S
T
GB
J
T
55
Publicidad
Tabla de contenido
