Things To Consider Prior To Mounting; How To Install/Replace The Batteries - Good Earth Lighting SE1295-BRS-02LF1-G Manual De Instrucciones

Things to Consider Prior to Mounting

SELECT A LOCATION THAT ALLOWS THE SENSOR TO
PERFORM AT ITS PEAK EFFICIENCY.
MINIMUM MOUNTING HEIGHT: 8 FT.
OPTIMAL MOUNTING HEIGHT: 8-10 FT.
Mounting above 10 ft. can decrease the sensor
detection range.
DO NOT mount near light sources (street lights, tra c).
DO NOT mount on the ground.
THE FIXTURE USES A PASSIVE INFRARED (PIR) MOTION SENSOR
AND AS SUCH DETECTS CHANGES IN INFRARED RADIATION OF
WARM OBJECTS MOVING ACROSS THE DETECTION ZONES.
The PIR sensor can be triggered by a variety of sources including dryer vents,
hot tubs, idling vehicles, etc.
The PIR sensor CANNOT detect motion through plexiglass, plastic, or glass barriers.
DO NOT aim the PIR toward areas with pedestrian and motorized tra c and/or other objects
that generate heat.
DO NOT mount near nighttime light sources (street lights, tra c). Light sources can cause the light to
operate in daylight mode.

How to Install/Replace the Batteries

Insert Batteries
2 Insert four new alkaline D cell batteries (not
included) into the battery compartment and match
the polarity marked on the back of the battery
compartment with the "+" and "-" markings.
4
Remove Battery Compartment Cover
1
Remove fixture from mounting bracket.
Remove all four (4) screws from the
battery compartment cover. Remove
the battery compartment cover.
Re-attach Battery Compartment Cover
Re-attach the battery compartment cover by aligning the compartment
3
cover onto the fixture. Close the compartment cover and then re-attach the
screws.
Low Battery Indicator Light
OPTIMAL
MOUNTING
HEIGHT: 8-10FT.
MINIMUM
MOUNTING
HEIGHT: 8FT.
PASSIVE INFRARED
(PIR) SENSOR ZONE
D D
1.5V 1.5V
Use alkaline batteries only. Do not use
carbon zinc batteries and DO NOT mix
battery type.
The red LED low battery indicator, inside
the motion sensor, will light up when the
batteries are low and need replacing.
Repeat all 3 steps on this page and
replace the batteries.
WALL/SURFACE
MOUNT
240° 180°
MOTION MOTION
COVERAGE COVERAGE
ZONE FROM
ZONE FROM
THE FIXTURE
THE FIXTURE
IS UP TO IS UP TO
40 FT.
40FT.
POSITIVE TERMINAL
Uses (4)-1.5 volt
Alkaline "D" cells
(Not included)
NEGATIVE TERMINAL
D D D D
1.5V 1.5V 1.5V 1.5V