System Parameters - Airzone Flexa 3.0 Guía Rápida

SYSTEM PARAMETERS

•
System address. (Not available on systems with BACnet gateway) This allows you to define
the number of the system in your installation. By default, it displays the value 1. The system
will show the free address values with a maximum value of 99.
EN
If you have address 1 and have an Airzone production control board (AZX6CCPGAWI) in the
installation, you can use the Supermaster function, which imposes the operation mode of
system 1 on the other systems connected to the AZX6CCPGAWI in a semi-forced way:
•
Temperature range
(19 – 30 °C) and minimum temperature for cooling mode (18 – 26 °C), in steps of 1 °C. If you
want, you can disable any of the modes. By default, the maximum heating temperature is
set to 30 °C and the minimum cooling temperature to 18 °C.
•
Combined stage
allows you to activate/deactivate the combined stage of the "Control stages" parameter in
the user "Zone settings" menu.
•
Hysteresis Config
temperature and the set-point temperature to begin to apply the RadianT algorithm, which
aims to prevent underfloor heating installations overheating. In installations with radiators,
set this value to 0 °C. By default, it is set to 0 °C.
•
Type of opening*
dampers. Proportionality scales the opening or closing of the damper in 4 steps according
to the temperature demand of the zone, adjusting the zone airflow rate. By default, it is set
to All/Nothing.
*Note: Changing this parameter affects all motorized dampers in the installation. It is not
recommended for RINT and RIC smart grilles.
Parameters not available in Airzone Blueface zero thermostats
1
14
Operation mode of system 1
. This allows you to select the maximum temperature for heating mode
1
. (Only available in installations with AZCE6OUTPUT8 modules) This
1
. This defines the temperature differential between the room
1
. This allows you to enable/disable the proportionality of the system
1
Available operation modes of the
other systems