Waterpik Sonic-Fusion 2.0 SF-03 Manual Del Usuario página 9

SONIC-FUSION TOOTHBRUSH
RESET INSTRUCTIONS
In the event that your Sonic-Fusion 2.0 becomes ON/OFF unresponsive, there are
two ways to reset your water fosser/toothbrush.
Radio Reset Steps:
1. Unplug the fosser base unit, wait 1 minute, Re-Plug base unit to AC-Mains.
This performs a base radio reset.
2. Press and hold the Toothbrush BRUSH button. Then sequentially Press
and hold the SPEED mode button; continue holding both buttons simultaneously.
The toothbrush may run for 3 seconds and then automatically shut of at the
3 second interval.
3. Continue to HOLD BOTH buttons for 5 seconds.
4. Afer 6 seconds RELEASE BOTH BUTTONS. This shall reset the toothbrush
to factory defaults. The toothbrush fuel gauge will also reset back to empty.
5. Place toothbrush in charging dock allowing radios to re-connect and begin
a charging cycle. Note: the toothbrush will not run until adequate battery
charge is provided back to the toothbrush indicated with at least a single solid
(non-fashing) fuel gauge light.
Toothbrush Reset Steps:
1. Press and hold the toothbrush FLOSS button for a duration of 10 seconds.
2. Afer 10+ seconds, release the FLOSS button. At this point the toothbrush
is reset to factory defaults. The toothbrush fuel gauge will also reset back
to empty.
3. Place toothbrush in charging dock allowing radios to re-connect and begin a
charge cycle. Note: the toothbrush will not run until adequate battery charge
is provided back to the toothbrush indicated with at least a single solid
(non-fashing) fuel gauge light.
9