General Characteristics Of The Operator; Main Operator Parts - Erreka CICLON CLS210 Manual Del Instalador

DESCRIPTION OF THE PRODUCT
2

GENERAL CHARACTERISTICS OF THE OPERATOR

The CLS210/CLS210F operator is constructed to form
part of a swing gate automation system.
It comprises a metal body, which contains the motor
and a planetary gears box. Model CLS210F also has a
brake and unlocking key to operate the gate manually
in the event of failure of the electricity supply. Allows a
maximum opening of approximately 130°.
This operator, along with its corresponding Erreka
control panel, allow the implementation of a soft stop.
3

MAIN OPERATOR PARTS

Fig. 2 Main components
36
Installation manual
system, with the speed slowing down at the end of the
closing and opening operations.
With model CLS210 it is necessary to install an electrical
lock, as is also the case with model CLS210F for leaf
lengths of over 1.8m.
Operator CLS210/CLS210F can be installed with an
articulated arm or with a sliding arm.
This operator allows us to fulfil the requirements of
standard EN 12453 without the use of peripheral
elements.
Components:
1 Operator body
2 Lock for unlocking (only
model CLS210F)
3 Drag wheel
4 Wall support
5 Arm (not included with the
operator)
Wires:
• Grey wire: motor (common)
• Brown wire: motor
(rotation 1)
• Black wire: motor (rotation 2)
• Orange wire: brake
• Violet wire: brake
• Red wire: power supply (+)
encoder
• White wire: power supply (-)
encoder
• Blue wire: encoder signal
• Yellow/green wire: earth