Preparations At The Workplace - Hilti NURON GDG 6-22 Manual De Instrucciones

Working diameter, accessory tool
Shank diameter, accessory tool
Width across flats, spindle
Width across flats, clamping nut
Storage temperature
Ambient temperature for operation
4.1 Battery
Battery operating voltage
Weight, battery
Ambient temperature for operation
Storage temperature
Battery charging starting temperature
4.2 Noise information and vibration values in accordance with EN 62841
The sound pressure and vibration values given in these instructions were measured in accordance with a
standardized test and can be used to compare one power tool with another. They can also be used for a
preliminary assessment of exposure.
The data given represent the main applications of the power tool. However, if the power tool is used for
different applications, with different accessory tools, or is poorly maintained, the data can vary. This can
significantly increase exposure over the total working period.
An accurate estimation of exposure should also take into account the times when the tool is switched off, or
when it is running but not actually being used for a job. This can significantly reduce exposure over the total
working period.
Identify additional safety measures to protect the operator from the effects of noise and/or vibration, for
example: maintaining the power tool and accessory tools, keeping the hands warm, organization of work
patterns.
Noise information
Emission sound pressure level (L
Uncertainty for the sound pressure level (K
Sound power level (L
WA
Uncertainty for the sound power level (K
Vibration information
Triaxial vibration value
Uncertainty (K)
5

Preparations at the workplace

WARNING
Risk of injury by inadvertent starting!
▶ Before inserting the battery, make sure that the product is switched off.
▶ Remove the battery before making any adjustments to the power tool or before changing accessories.
Observe the safety instructions and warnings in this documentation and on the product.
24 English
)
pA
)
pA
)
)
WA
B 22­55 2.4 m/s²
B 22­255 2.2 m/s²
B 22­55 1.5 m/s²
B 22­255 1.5 m/s²
Collet, 6 mm
Collet, 1⁄4 inch
Diameter of accessory tool
< 25 mm 25 ... < 50 mm
5 m/s²
5.2 m/s²
1.5 m/s²
1.5 m/s²
2327660
≤ 55 mm
6 mm
1/4 in
12 mm
17 mm
−20 ℃ ... 70 ℃
−17 ℃ ... 60 ℃
21.6 V
See the end of
these operating
instructions
−17 ℃ ... 60 ℃
−20 ℃ ... 40 ℃
−10 ℃ ... 45 ℃
72 dB(A)
3 dB(A)
83 dB(A)
3 dB(A)
50 ... 55 mm
27.5 m/s²
28.3 m/s²
1.5 m/s²
1.5 m/s²
*2327660*