Publicidad
Idiomas disponibles
Idiomas disponibles
Installation
Step 1
Measure the opening you wish to mount the mesh gate. The wall brackets can be
mounted inside (1a) or outside the door frame (1b).
1a
Step 2
The mesh part of this gate can be rolled out from any angle.(2a) Do not overextend the mesh panel
on this gate – it is intended for use in openings up to 55" only. Cut template along dotted line and
remaining margin along floor line. Vertically align and hang template against the wall or door frame.
Mark screw hole positions on wall or door frame with a pencil or marker. (2b)
2a
Using a drill bit 1/8 inch or smaller, create a pilot hole at each of the marked screw locations.
Step 3
Secure both mounting (3a, 3b) and latching (3c, 3d) brackets with the screws provided.
NOTE:
Refer to the chart on page 2 regarding usage of spacers for mounting on baseboards.
3a
Step 4
Align the bottom of the mesh gate onto the lip of the lower mounting bracket (4a), then push the
gate in and down slightly onto the upper mounting bracket (4b) until it clicks (4c). Ensure it is securely
locked in place.
4a
1
1b
2b
2b
1
3b
4b
3
NOTE:
to solid materials only – you
may need to use a studfinder to
locate the stud behind drywall.
Number on template indicates side:
1 – Mounting side
2
2 – Latching side
3c
4c
2
click!
Ensure you are mounting
3d
Swivel latch
Page 3
Publicidad
