Whalen SPUS-DZMF-LBM Manual De Instrucciones página 15

30. Stand the assembled unit upright. With the pilot holes as a guide, attached eight Metal Brackets (9) at the
joints where the Bottom Stretchers (F and G) meet the Side Panels (B and C), using two 14 mm Screws
(7) per bracket.
B
31. Insert the assembled Lower Drawer with Caster into the lower frame. Extend the Ball Bearing Slide
Tracks on the panels all the way forward (including ball bearing cart). Then align the Slide Runners on
the assembled drawers with the Slide Tracks and push the drawer carefully inside until it stops.
NOTE: If the drawer does not go in smoothly, please take it out and repeat the step. If you need to
remove the drawer, please pull the drawer all the way out, then simultaneously pushes the plastic release
lever of the ball bearing slides up on one side and down on the other side, and then pull it completely out.
32. Repeat the same procedure to insert the assembled Upper Drawer into the upper frame.
Assembly Instructions
C
B
F
G
C
15
B/C
7 9
F/G
Drawer Installation
Ball bearing cart
FRONT
FRONT
Ball bearing cart