Rupes HLR75 Manual De Instrucciones página 9

Polishing Foam
- Used polishing pad can be removed by simply tearing them off;
- Apply the new polishing pad by pressing the same on the backing pad;
NOTICE: Only Ø 80-100 mm polishing foam for backing pad Ø75 mm are allowed.
NOISE EMISSION VALUES
Noise emission values determined according to IEC 62841-1:
SOUND PRESSURE LEVEL
SOUND POWER LEVEL
UNCERTAINTY (K)
Use ear protection!
VIBRATION EMISSION VALUES
Vibration total values a h (triax vector sum) and uncertainty K determined according to IEC 62841-1:
3 AXIS VIBRATION LEVEL (a h )
UNCERTAINTY (K)
Displayed emission values are comparative and are to be employed for a provisional assessment of the operator's
risk exposure during the work period. Appropriate evaluation of work period must also include tool's idle and stop
periods. These emission values represent the tool's main applications. If the tool is used for other applications,
with other accessories, or if it does not undergo regular maintenance, emission values can significantly increase
during operations.
CAUTION: The indicated measurements refer to new power tools. Daily usage causes the noise and
vibration values to change.
MAINTENANCE AND SERVICING
WARNING: All maintenance operation must be performed with the power disconnected.
Make sure to remove the power supply 9HP180LT or battery pack 9HB180LT from the tool and that the
knob is in the OFF position.
CLEANING
At the end of each work session, or when required, remove any dust from the body of the tool using a soft cloth,
paying particular attention to the motor ventilation slots.
No other maintenance operations must be undertaken by the user.
REPAIRS
Maintenance and cleaning of the inner parts like ball bearings, gears etc. or others, must be carried out only by an
authorized customer service workshop.
DISPOSAL (WEEE DIRECTIVE)
For EU countries only: According to the European Directive on Waste from electrical and electronic
equipment and its implementation in conformity with national standards, exhausted electrical equipment
must be collected separately, in order to be recycled in an environmentally friendly way. The product, when
it reaches the end of its life, must not be dispersed in the environment or thrown away as household waste.
It must be disposed at authorized recycling centres (contact your local authorities to know where to dispose
of the product according to the law). The correct disposal of the product contributes to the health and
preservation of the environment. Illegal disposal of the product will entail penalties against the offenders.
dB(A)
dB(A)
dB(A)
m/s
2
m/s
2
HLR75
70.5
81.5
3.0
HLR75
2.5
1.2
9