Brita PURITY 450 Steam Instrucciones De Sustitución página 12

6 Inserting the filter cartridge
7 Commissioning
Flushing and bleeding the filter cartridge
Note: A bucket with a capacity of at least 10 litres is needed for flushing/bleeding.
EN
12
•
Check that the O-ring seal of the filter cartridge
groove and also check for dirt and damage.
Note: The cartridge seat has been lubricated with food-safe lubricant at the
factory.
•
Check the connecting seat for the O-ring of the filter cartridge
sure vessel lid for dirt and damage.
3
•
Place the new filter cartridge
• Stand on the kick loops
turning it clockwise until the mantle handles
•
Stand on the kick loops
on the pressure vessel
3
handle must match the "INSERT" groove.
20
•
Press the pressure vessel
clicks into place
15
•
Position the filter system horizontally.
•
Place the bucket under the flushing hose and open the flushing valve
•
Open the inlet valve
bucket. Rinse with at least 10 litres of water.
•
Close the flush valve
•
Carefully open the flush valve
Flush again with at least 10 litres.
•
Close the flush valve
• Check system for any leaks.
•
Note the installation date of the filter system and the next replacement date
on the enclosed sticker (orange) and attach it to the service pass on the pres-
sure vessel .
1
Note: Do not stick over the top sticker with the installation date.
•
Switch on power supply to the appliance (plug).
in the pressure vessel
2
with both feet, raise the pressure vessel
12
with both feet and place the pressure vessel lid
12
. The positioning of the arrow marking on the lid
1
down and turn anti-clockwise until the lock
3
.
on the inlet hose
7
, put down the filter and empty the bucket.
9
while holding the flush hose in the bucket.
9
.
9
is correctly seated in the
2
2
.
1
are over the kick loops
16
holding the flush hose in the
6
in the pres-
while
1
.
12
.
9