Install The Door Control - LiftMaster ATSW Manual Del Usuario

Install the Door Control

1 Install the Door Control
To prevent possible SERIOUS INJURY or DEATH from electrocution:
Be sure power is NOT connected BEFORE installing door control.
l
Connect door control ONLY to 12 VOLT low voltage wires.
l
To prevent possible SERIOUS INJURY or DEATH from a closing door:
Install door control within sight of door, out of reach of small children at a minimum height of 5 feet (1.5 m)
l
above floors, landings, steps or any other adjacent walking surface, and away from ALL moving parts of
door.
NEVER permit children to operate or play with door control push buttons or remote control transmitters.
l
Activate door ONLY when it can be seen clearly, is properly adjusted, and there are no obstructions to door
l
travel.
ALWAYS keep door in sight until completely closed. NEVER permit anyone to cross path of closing door.
l
INTRODUCTION
® ®
Compatible with myQ and Security+ 2.0 accessories, see page 36. Your door operator is compatible with up to 2
Smart Control Panels or 4 of any other Security+ 2.0
party products are not compatible.
Install door control within sight of door, out of reach of small children at a minimum height of 5 feet (1.5 m) above
floors, landings, steps or any other adjacent walking surface, and away from ALL moving parts of door. For gang box
installations it is not necessary to drill holes or install the drywall anchors. Use the existing holes in the gang box.
NOTE: Your product may look different than the illustrations.
®
door controls. NOTE: Older LiftMaster door controls and third
HARDWARE
Screw 6ABx1" (2)
1. Strip 1/4" (6 mm) of insulation from one end of the wire and separate the wires.
2. Connect one wire to each of the two screws on the back of the door control. The wires can be connected to
either screw.
3. Mount the door control with the hardware provided.
2
1
1/4" (6 mm)
17
3