Panel Control - Powersmart DB2805RB Manual Del Usuario

To Stop Snow Blower
1. Release the auger trigger.
2. Remove safety key.
3. Remove the battery pack and store in a secure location out of the reach of children.
WARNING: The thrower will turn off automatically after 5 seconds of stop operation.
To engage drive trigger
1. Squeeze the drive trigger against the left or right handle to engage the wheel drive for propelling
unit.
2. Release trigger to stop movement
Adjusting the Chute
The chute can be adjusted to change both the direction and the distance of
the discharged snow to assist you in moving snow away from one area and
placing it in another.
The throwing distance of the snow blower is adjusted by moving the
handle on the panel. Moving handle to forward and reverse on the panel to
adjust the deflector degree.
WARNING: Do not force the chute so far forward that a gap appears
between the deflector and the chute itself. Snow or other debris could be thrown through the gap and
back at the operator, resulting in serious personal injury.
WARNING: Do not adjust the chute deflector while the bail switch is engaged. Always release
the bail switch before adjusting the chute deflector.

Panel Control

WARNING! AVOID INJURY. Read and understand the entire safety section before
proceeding.
Snow blower controls and features are described below.
IMPORTANT! DO NOT change motion from forward to reverse with trigger engaged.
11