Kobalt KID 124B-03 Manual De Instrucciones página 12

OPERATING INSTRUCTIONS
• The speed range AND the mode selection cannot be active at the same time. You can only
activate either one of the speed ranges OR one of the modes.
• Do not change the speed setting when the tool is running. The speed range will not change
until you release the variable-speed trigger switch.
7. Mode Selection
This tool features two modes: FINISH and SELF
TAP. The modes are switched using the mode
button (E) located on the base of the tool.
To engage the FINISH or SELF TAP mode:
a. Attach the battery pack to the tool.
b. Position the direction-of-rotation selector (B) to
the left of the tool for forward rotation. FINISH
and SELF TAP modes do NOT work in reverse
rotation.
c. Depress and release the variable-speed trigger
switch (C) to "wake up" the control panel.
d. Press the mode button (E) to select the mode.
Every time you press the mode button, the
mode will be switched. The green light on the mode button will illuminate to indicate that it
is activated.
NOTICE:
• The LED indicator will turn off within approximately 1 min after the variable-speed trigger
switch or mode button is released, and will revert to the previous setting when the tool is
turned on again.
• The speed range AND the mode selection cannot be active at the same time. You can only
activate either one of the speed ranges OR one of the modes.
• When the mode button is pressed with the tool set to reverse rotation, the tool will return to a
specific speed range, but the FINISH and SELF TAP modes will not be available.
7
E
12