Care And Maintenance - Kobalt KID 124B-03 Manual De Instrucciones

OPERATING INSTRUCTIONS
10. Tightening and Loosening Screws and Nuts
a. Install the correct bit.
b. Select the mode as necessary, according to the work piece.
c. Select the suitable speed range for the application. It is advisable to make a trial driving on
a scrap material to determine the speed selection.
d. Apply just enough pressure to keep the bit engaged on the screw or nut.
e. Apply minimal pressure to the variable-speed trigger switch initially. Increase the speed
only when you can maintain full control.
WARNING
• Do not overtighten, as the force of the impact driver can break the fastener. Keep the impact
driver at a right angle to the fastener to avoid damaging the fastener head.

CARE AND MAINTENANCE

All maintenance should only be carried out by a qualified service technician.
Cleaning
Before cleaning or performing any maintenance, remove the battery pack from the tool.
For safe and proper operation, always keep the tool and its ventilation slots clean.
Always use only a soft, dry cloth to clean your impact driver; never use detergent or alcohol.
15