Installation Instructions - HotSpring HOT SPOT Serie Manual Del Propietário

INSTALLATION INSTRUCTIONS

All 115 volt spa models come equipped with approximately 15 feet
(15 m) of useable power cord (this is the maximum length allowed by
Underwriters Laboratory and the National Electric Code). When the spa
is installed, the power cord will come out of the bottom of the equipment
compartment door. For your safety, when the electrician is installing the
single electrical outlet and waterproof cover, the outlet should be no
closer than 5 feet (1.5 meters) and no farther than 10 feet from the spa
[reference National Electrical Code 680-6a(1) and 680-41a].
The Ground Fault Circuit Interrupter (GFCI) is located at the end of the
power cord. This device is for your protection. It is very important to
protect it from rain and other moisture. Test once a month, with the plug
connected to the power supply,
1. Push the "TEST" button on the GFCI breaker. The
spa should stop operating and the GFCI power
indicator will go out.
2. Wait 30 seconds, then push the "RESET" button.
Power will be restored to the spa and the GFCI
power indicator will turn on.
Electrical Requirements
English Spanish
If the GFCI fails to operate in this manner, your spa may have an
electrical malfunction, and you may be risking electrical shock. Turn off
all circuits and do not use the spa until the problem has been corrected
by an authorized service agent.
WARNING: Removal of the GFCI from the spa's power cord will
result in an unsafe spa and will void the spa's warranty.
IMPORTANT: Should you ever find the need to move or relocate
your HOT SPRING spa, it is essential that you understand and apply
these installation requirements. Your HOT SPRING spa has been
carefully engineered to provide maximum safety against electric shock.
Remember, connecting the spa to an improperly wired circuit will
negate many of its safety features.
Page 26
French