Work Before Start-Up - Zipper Maschinen ZI-WP700TN Instrucciones De Servicio

1. Check that the neutral connection and protective earthing are functioning properly.
2. Check that the supply voltage and frequency correspond to the specifications of the machine.
Deviation of the supply voltage and frequency
A deviation from the value of the supply voltage of ± 10 % is permissible.
A short-circuit fuse must be provided in the power supply system of the machine!
3. Find the required cross-section of the supply cable (it is recommended to use a cable type
H07RN (WDE0282), taking measures to protect against mechanical damage) in a current ca-
pacity data sheet.
4. Make sure that the power source is protected by a residual current circuit breaker.
5. Connect the unit only to a properly grounded outlet.
6. When using an extension cable, make sure that it is dimensioned appropriately for the con-
nected load of the machine (the connected load can be found in the technical data). You can
find the correlation between cable cross-section and cable length in specialist literature or con-
sult an electrician.
7. Only use extension cords that are also suitable for outdoor use. Using an extension cord suita-
ble for outdoor use reduces the risk of electric shock.
15 OPERATION

15.1 Work before start-up

• Make sure that the saw blade is firmly secured, in perfect condition, sharpened and guaran-
teed to run smoothly.
• Make sure that the rocker unit with the log carriage is fully extended before each use. Other-
wise there is an increased risk of recoil.
• When cutting material, pay attention to foreign objects such as wires, nails, etc. as well as
irregularities in the material, such as knots.
• Check that the moving parts are working properly and are not jammed.
• Ensure that the machine is securely anchored to the ground.
• Ensure that the correct power supply and cable are used. Insert the plug into the socket.
ZIPPER MASCHINEN GmbH
ZI-WP700TN
Check the direction of rotation of the motor! Switch the ma-
chine on briefly. Correct running direction: see arrow on the saw
blade cover or the saw blade.
If the running direction is set incorrectly, switch the machine off
immediately – danger of injury by loosening the saw blade.
Change the direction of rotation by inserting a screwdriver into
the slot provided for this purpose in the plug and adjusting the
correct direction of rotation with slight pressure by moving it to
the left or right (turn the phase inverter by 180°).
www.Zipper-Maschinen.at
N O I T I C E
WARNING
OPERATION
28