Unlocking The Machine; Setting The Log Ruler; Operating; Start/Stop - Zipper Maschinen ZI-WP700TN Instrucciones De Servicio

15.1.1

Unlocking the machine

15.1.2

Setting the log ruler

15.2 Operating

15.2.1

Start/Stop

Starting the machine: press the green ˝I˝ button on the ON-OFF switch.
Stopping the machine: press the red ˝O˝ button on the ON-OFF switch.
15.2.2

Workflow

1. Switch on the machine.
2. Open the top guard.
3. Position the cut material into the log carriage on the completely extended rocker unit.
4. Close the top guard again.
ZIPPER MASCHINEN GmbH
ZI-WP700TN
www.Zipper-Maschinen.at
NOTICE: the locking plate (1) must be released be-
fore start-up of the machine (see Fig. H)!
1. Loosen the star screw (1) so that the log ruler
(2) can be pulled out (see Fig. I, Pic. 1).
2. Use the scale to set the desired length of the
workpiece (see Fig. I, Pic. 2).
3. Turn the log ruler (2) clockwise to the top (see
Fig. I, Pic. 3).
4. For fixation, retighten the star screw (1) (see
Fig. I, Pic. 4).
OPERATION
29