cecotec BOLERO AGUAZERO 8000 FULL BUILT-IN Manual De Instrucciones página 44

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 21
ENGLISH
22. ECO: This is the standard programme, suitable for cleaning normally soiled dishes and the
most efficient programme in terms of combined energy and water consumption for such
dishes.
23. Glass: For lightly soiled crockery and glassware.
24. 90 min: For normally soiled loads that need to be washed quickly.
25. Rapid 30': For lightly soiled loads such as glasses, crystal and fine china.
26. Self-cleaning: This programme provides an efficient cleaning of the own dishwasher.
Power save
Manual pre-wash of the tableware will lead to higher water and energy consumption and
-
is not recommended.
Washing dishes in a household dishwasher generally consumes less energy and water
-
than manual dishwashing when the dishwasher is used according to the manufacturer's
instructions.
Starting a programme
1. Take out the upper and lower baskets, load the tableware and push them back inside. It is
recommended to load the lower basket first and then the upper basket.
2. Pour the detergent.
3. Press the power button.
4. Choose a programme and the indicator light will light up. Close the door. The dishwasher
will start the cycle.
Changing the programme mid-cycle
A programme can only be changed if it has been running for a short time, otherwise the
-
detergent may have already been released or the wash water with detergent may have
already been drained. In that case, the dishwasher needs to be prepared again for washing
and the detergent compartment needs to be refilled.
To re-adjust the dishwasher, follow these steps (Fig. 20):
-
1. Open the door slightly to stop the dishwasher. When the spray arms have stopped, you can
open it completely.
2. Hold down the '>' icon for more than three seconds. The machine will enter the programme
selection mode.
3. You can change the programme to the desired cycle setting.
4. Close the door and the dishwasher will resume the washing.
Introducing tableware during the cycle
You can add tableware at any time before the detergent compartment is activated.
-
In this case, follow the instructions (Fig. 21):
-
1. Open the door slightly to stop the dishwasher.
2. When the spray arms have stopped, you can open it completely.
86
3. Add the tableware you forgot.
4. Close the door.
5. The dishwasher will resume the programme.
Warning
It is dangerous to open the door in the middle of the cycle, as the hot steam can burn you.
Auto Open
After washing, the door will open automatically for better drying effects.
Note
-
The dishwasher door should not be blocked when the Auto Open function is on.
-
This could alter the functionality of the door lock.
-
The Rapid 30' and Rinse programmes cannot use the Auto Open functionality.
Important
Place the moisture barrier tape provided under the cabinet to prevent the accumulation of
condensation.
Adjusting the cutlery tray
-
Lift the left rack, adjust it to the lowest position, it will lie flat and the right rack will lie on
its side. Fig. 22
-
Lift the right rack, now both are flat. Fig. 23
-
Move the right rack from right to left, now they are both overlapping. Fig. 24
-
Remove the right rack from the tray, there will be the left rack left. Fig. 25
How to make the most of space. Fig. 26
You can place utensils like blenders, mugs, etc. without affecting the operation of the upper
basket.
Adjusting the tray height Fig. 27
Loosen the four buttons on the tray and push it down gently.
Adjusting the upper basket
Type 1:
The height of the upper basket can be set easily to create more space for large utensils
-
in the upper or lower basket.
To set the height of the upper basket, follow these steps:
-
1. Pull out the upper basket. Fig. 28
2. Remove the upper basket. Fig. 29
3. Place the upper basket again on the upper or lower rollers. Fig. 30
4. Push the upper basket inwards. Fig. 31
ENGLISH
87
AGUAZERO 8000 FULL BUILT-IN

Publicidad

Tabla de contenido
loading

Tabla de contenido