Hilti NURON SB 4-22 Manual De Instrucciones página 31

5. Push the rubber ring fully into the guide recess.
▶ The rubber ring lies correctly in the guide recess.
▶ The rubber ring does not lie correctly in the guide recess.
▶ Realign the rubber ring.
6. Re-install the bandsaw blade. → page 22
8 Transport and storage of cordless tools and batteries
Transport
CAUTION
Accidental starting during transport !
▶ Always transport your products with the batteries removed!
▶ Remove the battery/batteries.
▶ Never transport batteries loose and unprotected. During transport, batteries should be protected from
excessive shock and vibration and isolated from any conductive materials or other batteries that may
come in contact with the terminals and cause a short circuit. Comply with the locally applicable
regulations for transporting batteries.
▶ Do not send batteries through the mail. Consult your shipper for instructions on how to ship undamaged
batteries.
▶ Prior to each use and before and after prolonged transport, check the product and the batteries for
damage.
Storage
WARNING
Accidental damage caused by defective or leaking batteries !
▶ Always store your products with the batteries removed!
▶ Store the product and the batteries in a cool and dry place. Comply with the temperature limits stated in
the technical data.
▶ Do not store batteries on the charger. Always remove the battery from the charger when the charging
operation has completed.
▶ Never leave batteries in direct sunlight, on sources of heat, or behind glass.
▶ Store the product and batteries where they cannot be accessed by children or unauthorized persons.
▶ Prior to each use and before and after prolonged storage, check the product and the batteries for
damage.
9 Troubleshooting
If a problem occurs, always observe the charge-status and fault indicator of the battery. See the section
headed Status indicators of the Li­ion battery.
If the trouble you are experiencing is not listed in this table or you are unable to remedy the problem by
yourself, please contact Hilti Service.
Trouble or fault
Product does not develop full
power.
The product can't be
switched on.
Product does not start.
LEDs of the battery show
nothing
*2289590*
Possible cause
The control switch is not fully
pressed.
Switch-on interlock not activated.
Bandsaw blade blocked
Battery defective
2289590
Action to be taken
▶ Press the control switch fully.
▶ Activate the switch-on interlock.
▶ Check whether the saw blade is
fitted correctly and/or damaged.
▶ Contact Hilti Service.
English 25