Fall Arrest - Hilti NURON SB 4-22 Manual De Instrucciones

5. Slip the bandsaw blade over both rollers, one after the other.
6. Pivot the clamping lever through 180 ° in the direction of rotation until it is seated against the stop.
7. Check that the bandsaw blade tool is correctly guided over both rollers.
8. Refit the blade cover.
▶ Make sure that the cover is correctly seated.
9. Install the side handle. → page 23
10. Check that the bandsaw blade is correctly seated by repeatedly switching the bandsaw on and then off
again.
5.5 Installing belt hook
▶ Secure the belt hook with the 2 screws.
▶ Tighten the screws hand-tight. Before each use, always check that the belt hook is secure.
5.6 Installing the side handle
CAUTION
Risk of injury Loss of control over the bandsaw.
▶ Use the product only with the side handle fitted. Screw the side handle into the corresponding tapped
hole in the casing.
▶ Screw the side handle into the casing of the bandsaw, turning the side handle clockwise.
5.7

Fall arrest

WARNING
Risk of injury by falling tool and/or accessory!
▶ Use only the Hilti tool tether recommended for your product.
▶ Prior to each use, always check the attachment point of the tool tether for possible damage.
Comply with the national regulations for working at heights.
As drop arrester for this product, use only a combination of the Hilti retaining strap and the Hilti tool tether
#2261970.
▶ Secure the retaining strap to the installation openings for accessories. Check that it holds securely.
▶ Secure one carabiner of the tool tether to the retaining strap and secure the second carabiner to a
load-bearing structure. Check that both carabiners hold securely.
Comply with the operating instructions of the Hilti retaining strap and those of the Hilti tool tether.
6 Operation
Observe the safety instructions and warnings in this documentation and on the product.
6.1 Switching on
1. Activate the switch-on interlock.
2. Press the control switch.
For safety reasons, the control switch cannot be locked and has to be held down while the tool is
in operation.
*2289590*
3
4
2289590 English 23