Troubleshooting - cecotec bolero SQUAD I 3000 Manual De Instrucciones

6. TROUBLESHOOTING

Problem
The induction
hob does not
turn on.
The touch
controls do not
work.
It is difficult to
use the touch
buttons.
The glass is
damaged.
Some cookware
makes crackling
or popping
noises.
The induction
hob produces a
slight buzzing
sound when
used at high
power.
Possible causes
There is no power supply. Make sure the hob is connected to the
The buttons are locked.
There may be a slight
film of water on the
buttons or you may be
using your fingertip to
press the buttons.
Cookware with
rough edges. Use of
inappropriate and
abrasive scouring pads
or cleaning products.
This may be due to the
construction of your
cookware (layers of
different metals that
vibrate differently).
This is due to the
induction cooking
technology.
Possible solution
mains and it is on.
Check if there has been a power failure.
After these checks, if the problem persists,
please contact the official Cecotec Technical
Service.
Unlock the buttons. Check the 'Buttons lock'
section for instructions.
Make sure the touch control area is dry and
use your finger base to press the buttons.
Use cookware with flat and smooth
bases. Check the 'Selection of the suitable
cookware' section. Check the 'Cleaning and
maintenance' section.
This is normal for cookware and does not
indicate a fault.
It is usual, but the noise should decrease
or completely disappear by lowering the
power setting.
ENGLISH
BOLERO SQUAD I 3000
69