Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
hardness
Press
to adjust the hardness setting. This value should match the
hardness of the incoming untreated water supply. Press
changes or press
to return to the home screen.
Note:
Changing the hardness setting recalculates treatment
volume and regeneration interval.
4.1.2. Diagnostic mode
Press
from the home screens to view the diagnostic screen. Press the screen navigation arrows at the upper-right and left
of the screen to view each diagnostic parameter. Press
4.2.
SXT controller
Note:
The controller must be plugged to be programmed.
After 5 minutes without any button pressed, the unit returns to normal operation without saving.
4.2.1. Basic programming
Note:
Menus are displayed in a defined and incremental order.
Day of Override
Note:
Determine the maximum number of days of operation without regeneration.
Regeneration time
A
Press
and
B
Select the number of days of Override with
C
Press
to validate the selection and advance to the next parameter.
Note:
Determine the time of regeneration.
D
Adjust the regeneration time with
E
Press
to validate the selection and advance to the next parameter.
Feed Water Hardness
Note:
Determine the feed water hardness in °tH.
F
Adjust the water hardness with
G
Press
to validate the selection and advance to the next parameter.
Reserve capacity
Note:
Determine the reserve capacity in Litre or in percentage.
H
Adjust the reserve capacity with
I
Press
to validate the selection.
Ref. MKT-UG-054 / A - 03.06.2022
simultaneously for 5 seconds to enter the menus sequence.
and
and
.
and
.
to save your
to return to the home screen.
and
.
.
User Guide Fleck 5800-XTRi-XTR-SXT-LXT
Settings
hardness
300 mg/L
9 / 76
Publicidad
Tabla de contenido
