Safety Information; Use Of Hazard Information - Hach Clean & CAL pH Mount Manual Del Usuario

Specification
Dimensions
Weight
Material
Solution container volume
Flow cell volume
Power requirements
Battery pack charging temperature 0 to 35 °C (32 to 95 °F) maximum
Pressure rating
Pollution degree
Installation category
Environmental conditions
Operating humidity
Operating temperature
Storage temperature
Altitude
Certifications
Warranty
Section 3 General information
In no event will the manufacturer be liable for damages resulting from any improper use of product or
failure to comply with the instructions in the manual. The manufacturer reserves the right to make
changes in this manual and the products it describes at any time, without notice or obligation.
Revised editions are found on the manufacturer's website.

3.1 Safety information

The manufacturer is not responsible for any damages due to misapplication or misuse of this product
including, without limitation, direct, incidental and consequential damages, and disclaims such
damages to the full extent permitted under applicable law. The user is soley responsible to identify
critical application risks and install appropriate mechanisms to protect processes during a possible
equipment malfunction.
Please read this entire manual before unpacking, setting up or operating this equipment. Pay
attention to all danger and caution statements. Failure to do so could result in serious injury to the
operator or damage to the equipment.
Make sure that the protection provided by this equipment is not impaired. Do not use or install this
equipment in any manner other than that specified in this manual.

3.2 Use of hazard information

Indicates a potentially or imminently hazardous situation which, if not avoided, will result in death or serious injury.
Details
Refer to Dimensions on page 10
2.15 kg (4.75 lb)
Manifold assembly: PMMA; solution containers: LDPE; container cap and
quick-connect fittings: polypropylene with EPDM seals; tubing: PVC
compound
1 L
15 mL
Class II, USB power adapter: 100–240 VAC, 50/60 Hz input; 5 VDC at 2 A
USB power adapter output
Flow cell valve, drain valve, rinse water valve and sample valve: 414 kPa
(60 psi) maximum
2
I
Indoor use
0 to 95% RH, non-condensing
With battery pack: 0 to 35 °C (32 to 95 °F)
Without battery pack: 0 to 40 °C (32 to 104 °F)
–20 to 70 °C (–4 to 158 °F)
2000 m (6562 ft) maximum
CE, UKCA, FCC, ISED, RCM
1 year (US), 2 years (EU)
D A N G E R
English 5