Assembling And Finishing The Foot Shell - Blatchford Navigator NAV22LWW Instrucciones De Uso

9.3

Assembling and Finishing the Foot Shell

1
Location
Feature
2
3
4
1. Place the keel inside the glide sock and slide
them both into the foot shell.
Note... Make sure that the heel of the keel is fully
engaged in the location feature in the heel of the
foot shell.
Note... After assembling to the limb, make sure that
the glide sock is not trapped under the dome.
2. Pull the glide sock under slight tension.
3. Use a cable tie to secure the glide sock to the
pylon just above the adapter.
4. Remove the end of the cable tie, then fold the
glide sock over.
5. Abrade the top surface of the foot shell.
6. Bond a 12 mm pelite interface to the foot shell
and shape as appropriate. Use Evostik 528
(926213) or an equivalent.
7. Bond a foam cosmesis to the top surface of the
pelite interface and shape as appropriate . Use
Thixofix (926204), Evostik 528 (926213) or an
equivalent.
12
938247PK1/1-0421