JAC ROLLFORM Traducción Del Manual De Uso Original página 6

IMPORTANT: This machine must be earthed.
It is recommended that the system be protected with a fuse and an RCD.
Your mains electricity supply to the machine must be protected as indicated below:
- North America: 15 A protection;
- Rest of the world: 16 A protection.
For machines equipped with a variable speed drive, it is imperative that they be connected to a
junction box on a circuit fitted with a 300 mA RCD.
Note: Any problem resulting from any other type of connection will not be covered under warranty.
Before connecting the machine to the mains supply and in order to prevent the motor from burning
out when it is switched on, it is important to check that the mains supply matches the machine
specification (see machine nameplate).
This machine complies with Machinery Directives 2006/42, 2014/35, 2014/30 and is CE-marked as
proof of this compliance.
Please familiarise yourself with the safety pictograms displayed on the machine:
This pictogram indicates an electrocution hazard. Please isolate the machine
before carrying out any work on it. You will find this pictogram on the control panel
which doubles as an electrical enclosure (fig7, n°8).
You will find the circuit diagram for the machine inside the electrical enclosure
(fig7, n°9).
5.4 Commissioning
Before commissioning, ensure that there are no extraneous objects interfering with the machine's
moving parts.
Ensure first of all (after verifying electrical compatibility) that the motor is rotating in the right direction.
Do this by pressing the button and checking that the front box belt does actually move towards the
rear.
If this is not the case, disconnect immediately and switch two phase wires in the plug.
For machine operation, please refer to the "Operation" chapter.
5.5 Hazard
If the user or the machine is in danger, use the emergency stop to cut the power supply to the machine.
Remove the plug from the mains socket before any maintenance and/or servicing work.
Any maintenance work or replacement of parts must be carried out by an approved agent.
6