Content Of The Packaging; Wall Mounting - Melchioni Family BLANCO PLUS Manual De Usuario

fire, electric shock, or injury to persons.
➢
Avoid the use of an extension cord because the extension cord may overheat and cause a risk of fire.
➢
To prevent overloading a circuit, do not plug the heater into a circuit that already has other appliances working. Do
not install the heater under the wall socket.
➢
It is normal for the plug to feel warm to the touch; however, a loose fit between the AC outlet (receptacle) and plug
may cause overheating and distortion of the plug. Contact a qualified electrician to replace loose or worn outlet.
➢
The output of this heater may vary and its temperature may become intense enough to burn exposed skin. Use of
this heater is not recommended for persons with reduced sensitivity to heat or an inability to react to avoid burns.
➢
Do not cover the heater under no circumstance.
SAVE THESE INSTRUCTIONS
UNPACKING AND WALL MOUNTING INSTRUCTIONS
• After removing the packaging, make sure of the integrity of the appliance; if in doubt, do not use it and contact
professionally qualified personnel. The packaging elements (plastic bags, expanded polystyrene, nails, etc.) must not be
left within reach of children as they are potential sources of danger; dispose of them according to current regulations.
• Before connecting the appliance, check that the voltage values indicated on the data plate correspond to those of the
electrical network, and that the socket is effectively earthed. Check that other high absorption appliances are not connected
to the power line, to avoid overloads and fire risks. In case of incompatibility between the socket and the plug of the
appliance, have the socket replaced with another of a suitable type by professionally qualified personnel, who ensures that
the section of the socket cables is suitable for the power absorbed by the appliance. In general, the use of adapters and /
or extensions is not recommended; if their use becomes indispensable, they must comply with current safety standards
and their current capacity (amperes) must not be less than the maximum of the device.
• Place the appliance away from other heat sources, from flammable materials (curtains, upholstery, etc.), from flammable
gases or explosive material (spray cans) and from materials that can deform with heat.
• The support surface must be stable, wide (shelves are to be excluded), not sloping (as the appliance could overturn), and
without rough edges for the safety switch located in the base to work correctly: this switch stops operation if the stove
overturns.
• Make sure that the cable is positioned correctly and that it is not in contact with hot parts or sharp edges, nor wrapped
around the appliance or twisted on itself and does not get caught, in order to avoid a fall of the appliance. Make sure that
you cannot trip over it, to avoid accidental falls or personal injury. Also check that the cord is not under carpets
• In the event of a breakdown or malfunction, switch off the appliance and have it checked by professionally qualified
personnel; repairs carried out by unqualified personnel can be dangerous and void the warranty

CONTENT OF THE PACKAGING

- Heater: 1 piece
- 1 set accessory package:
• Dowels: 4
• Screws: 4
• Screw caps: 4
• Instruction manual: 1

WALL MOUNTING

1) Mark the positions of the four holes to be drilled on the wall. (It is better to install the appliance from 20 to 100 cm in
height from the floor for best performance).
2) Drill the wall with the 8 mm diameter bit.
3) Insert the plastic plugs into the holes.
4) Secure the panel with the screws provided
5) Screw the four fixing screws into the anchors.
6) Cover the screws with plastic caps. We recommend using regular glue to fix the caps on the head of the screws.
7) To remove the appliance from the wall, simply remove the caps and unscrew the screws with a screwdriver, then lower
the heater.
8) Make sure that the distance between the bottom of the stove and the floor is not less than 20 cm when the appliance is
installed.