•
Stand the appliance on a horizontal, flat surface or table; do not stand on a inclined plane
(the appliance could upset). Make sure the safety system get in touch with the floor,
otherwise the appliance doesn't work.
•
Make sure that the cable is correctly positioned, that it is not touching hot elements or
sharp edges, is not wound around the utensil, is not twisted up on itself or in the way to
prevent the utensil from being pulled over. Check that you cannot trip over to prevent
accidental falls or harm to persons.
All repairs should be made by a competent qualified electrician. In any case you should
return the appliance to this service.
DESCRIPTION OF THE APPLIANCE
ASSEMBLY
Before each use, check that the appliance is in good condition and that the power cable is not
damaged: if the power cable is damaged, it must be replaced by the manufacturer or its
technical assistance service or in any case by a qualified person. similar, in order to prevent
any risk.
Attention: the stove can only be used if complete with wheels.
1. Carefully turn the machine over to assemble the wheels.
2. Take the plates and wheels and place the wheels on the plates.
3. Unscrew the wing nut and slide the wheel plate into the correct position.
4. Secure the plate by relieving the wing nut.
5. Place the appliance in an upright positio.
1. Air inlet grille
2. Operation knob
3. Thermostat
4. Protection grid
5. Swiveling wheels
6. Quartz lamps
12