Replacing The Lamp; Closing The Door - AEG AWUS040B8B Manual De Instrucciones

70 www.aeg.com
Problem
Water flows on the rear plate
of the appliance.
Water flows inside the wine
cabinet.
Water flows inside the wine
cabinet.
The temperature in the wine
cabinet is too low or too
high.
If the advice does not lead to
the desired result, call the
nearest brand-mark service.

9.2 Replacing the lamp

The appliance is equipped with a longlife
LED interior light.
Only service is allowed to replace the
lighting device. Contact your Authorised
Service Centre.
Possible cause
During the automatic de‐
frosting process, frost
melts on the rear plate.
The appliance drain is
clogged.
Products prevent that wa‐
ter flows into the water col‐
lector.
The temperature regulator
is not set correctly.
The door is not closed cor‐
rectly.

9.3 Closing the door

1. Clean the door gaskets.
2. If necessary, adjust the door. Refer
to the "Installation" chapter.
3. If necessary, replace the defective
door gaskets. Contact the Authorised
Service Centre.
Solution
This is correct.
Clean the appliance drain
hole. Refer to the "Cleaning
the drain" section.
Make sure that products do
not touch the rear plate.
Set a higher or lower tempera‐
ture.
Refer to the "Closing the door"
section.