Kärcher BRS 43/500C 115V Manual De Instrucciones página 15

13. Unplug motor wires. Loosen end cap screws, 1 full
turn.
END CAP
SCREWS
ACCESS HOLE
FOR LOWER
SCREW
BELT
PULLEY
RIGHT SIDE
FRONT
14. Back off set screws to release belt tension.
15. Remove the motor clamps and lift brackets.
16. Remove belts and belt covers.
17. Lift motor out of housing. Remove pulleys and
adjustment bracket with screw. Set parts aside for
re-installation.
18. Take the new motor and loosen the screws in the
long rear drive end cap. This allows the end cap to
swivel +/- 20 degrees. Do not remove the end cap
screws, only back them off 1 full turn. Install adjust-
ment bracket to the opposite end. Torque to 40 in-
lbs (4.5Nm)
19. Put the motor in the cradle on the frame. Place
pulleys onto motor shaft's. Loop the drive belt onto
the right motor drive pulley
NOTE: Do not let the pulleys extend more than
0.5mm (0.02in) past the motor shaft.
20. Reinstall the motor clamps, only tighten the rear
screws. The front screws will be tightened later.
21. From the bottom, remove the left driver plate (front
brush).
MOTOR
REAR
BELT
LEFT SIDE
PULLEY
8.644-468.0 Manual Operator BRS 43/500C 115V
22. Loop and align the belt on the motor pulley.
23. Install one screw from the service kit (P/N 8.635-
232.0) into the pulley, captured by the belt.
24. Rotate the pulley to install the second captured
screw.
25. Use the 2 screws to rotate the assembly to install
the third screw.
26. Rotate the pulley and guide the belt onto the pulley.
To ensure proper alignment, reverse rotation may
be necessary. Use caution when prying against the
frame.
27. Gently pry the motor up from the frame and tighten
the left set screw. Use the kit's distance tool to
center the motor and set the belt tension.
28. Repeat the previous step for the right set screw.
29. Place lift brackets on motor, align over pins.
HANDLE MOUNT
ASSEMBLY
ROTATE MOTOR
RIGHT HAND
GEAR DRIVE
LIFT BRACKETS
MOTOR CLAMPS
30. Tighten the screw in the long gear drive cap.
31. Tighten all four motor clamp bolts.
32. Check both belts for equal tension. The belts
should not sag under their own weight, however,
should flex easily when squeezed with fingers. If
the tension is clearly unequal, loosen the motor
mount bolts and retighten. This will equalize the
belt tension from on side to the other.
33. Reinstall finger guards.
34. Reinstall lift brackets with top surface lip on inside.
35. Reinsert circuit breaker through hole in cover,
reattach cover, circuit breaker boot, and wiring
grommet.
Maintenance
ROTATE MOTOR
LEFT HAND
GEAR DRIVE
15