Entering Or Changing The Job Number; Downloading The Reports; Selecting The File Format - HURNER HST 300 GeoTherm+ 2.0 Manual De Instrucciones

H Ü R N E R S c h w e i s s t e c h n i k G m b H
Nieder-Ohmener Str. 26
35325 Mücke, Germany
play 6), either for viewing or for entering or changing/
confirming them.
6.2

Entering or Changing the Job Number

The commission number input screen is shown by the unit
before welding or accessed by the user in the quick access
screen (Display 6). It can be entered by pressing the ï, ð,
ñ, ò cursor keys or by reading it from a bar code using
the scanner. The maximum length is 32 characters. Confirm
your input by pressing the START/SET key. The job number
will be saved to memory and will appear in the printed
welding report.
7

Downloading the Reports

Interface
(see next page)
USB A Interface Port
for connecting USB mass storage media (such as a
memory stick)
The interface port complies with the USB version 2.0
specification (i.e., maximum data rate of 480 megabits
per second).
Before transferring data, it is highly recommended
to switch the welding unit off and on again. If this
fails to happens, there is a risk of data transfer
Important
failure, or reports in the welding unit may be cor-
rupted.
When transferring welding reports to a USB stick,
always be sure to wait until the display shows the
"Download finished" message before you discon-
Important
nect the USB stick from the product. If you discon-
nect it too early, the unit may ask you whether you
want to delete the reports in memory, although
they were not properly transferred. In this case,
if you delete the contents of the report memory,
the welding reports would be irrevocably lost and
would not be available elsewhere either.
7.1

Selecting the File Format

Connecting the storage media causes the the screen to
appear in which the format of the output file with the
welding reports can be selected: a PDF file with an ab-
stracted or extended version of the report or the format
of the welding data management application DataWork.
Version September 2022 HÜRNER HST 300 GeoTherm + 2.0 User's Manual
Enter Job No.
********************
************
Display 7
Select File Type
DataWork File
>PDF Abstract
PDF Ext'd Report
Display 8
EN
13