Entering Or Changing The Commission Number; Entering Or Changing The Joint Number - HURNER WeldControl 2.0 1200 Manual De Instrucciones

H Ü R N E R S c h w e i s s t e c h n i k G m b H
Nieder-Ohmener Str. 26
35325 Mücke, Germany
The code has to be an ISO-compliant code. It can be entered either
using the cursor keys and confirming the input by pressing the START/
SET key, or by reading a RFID transponder card or scanning it from a
bar code with the optional handheld scanner.
When the code was properly scanned or entered, this is confirmed by
an audible signal.

4.2.2 Entering or Changing the Commission Number

From Display 3 or after the welder identification code was entered, the
machine requests the input of the job number, or commission number,
of a maximum 32 characters, if it was enabled in the Configuration
Menu. If a commission number exists already in memory, this one is
proposed. You can either confirm it by pressing START/SET or change it
using the cursor keys or reading it with the scanner or from a RFID card
and then confirm the new number by pressing the START/SET key.
It is possible to select a previously saved commission number instead
of the one shown on the screen by pressing the ï and ð cursor keys
simultaneously. This causes the screen to show in which you can scroll
through the commission numbers in memory using the ï and ð keys,
to select a number and then confirm it by the START/SET key. This
number will be used for the next welding. To quit the scroll mode
without selecting a commission, press the STOP/RESET key.

4.2.3 Entering or Changing the Joint Number

From Display 3 or after the commission number was entered, the ma-
chine requests the input of the welding number, or joint number, if it
was enabled in the Configuration Menu.
The joint number, or welding number, is based on the job/commission
number. This means that it increments by 1 for every welding opera-
tion performed in the scope of the current commission (identified
previously by entering the appropriate job number). In the example in
Display 3, the next welding operation will be saved to welding report
number 72 while the joint itself is joint number 2 of the current job/
commission.
The first joint of a commission for which no joint has been
saved to memory so far, always receives no. 1. If the memory
already holds joints for a commission, the machine finds the
highest number of the joints existing for that commission
Info
and uses this number plus 1. The user is shown the number
thus found on the screen and can apply or change it. If the
user changes the joint number, it is his responsibility to make
sure that no number is assigned twice in one commission. If
a joint number appears twice in a commission, this will not
affect the welding process and the logging of its data in
any way. However, in that commission two joints will not be
distinguished by a unique number.
If user inputs leave some joint numbers unused (for instance,
for a given commission no. 1, 2, 3, 5, 6, 9), the gaps do not
get filled, and the automatically found number proposed for
the next welding operation will still be the highest existing
number plus 1 (that is, 10 in this example).
The joint number can also be entered after simultaneously pressing
the cursor keys ï and ð when Display 3 is showing on the screen.
Version July 2020 HÜRNER WeldControl 2.0 1200 User's Manual
Enter Commission No.
++++++++++++++++++++
++++++++++++
Display 12
EN
15