Product Description; Lcd Screen; Battery Information - LEXIBOOK RP510AV Manual De Instrucciones

Ocultar thumbs

Contenido

página de 33

/ 33
Contenido
Tabla de contenido
Marcadores

Tabla de contenido

Idiomas disponibles

1. MODE button: selects the setting mode.

2. RADIO button: press this button to turn the radio on or off and to snooze the

3. VOL. button: press this button to control the volume. Press once, and then

4. LCD screen

5. Battery compartment (at the bottom of the unit)

6. Night-light rubber feet

7. DOWN button: press this button to change the radio frequency or to turn the

8. UP button: press this button to change the radio frequency or to turn the

9. Iron Man button

10. Speaker

11. Projector

12. PROJECT button: projects the time onto the ceiling.

Your Avengers Radio Alarm Clock Projector works with 4 x 1.5V

batteries (not included).

When you use the RP510AV for the first time:

1. Using a screwdriver, open the battery compartment

cover located at the bottom of the unit.

2. Install the 4 x AA/LR6 1.5V

observing the polarity markings inside the battery

compartment.

3. Close the battery compartment and tighten the screw.

IMPORTANT NOTE: For better performance, it is recommended to use alkaline

batteries with this product.

Non-rechargeable batteries are not to be recharged. Rechargeable batteries are to be

removed from the product before being charged. Rechargeable batteries are only to be

charged under adult supervision. Different types of batteries or new and used batteries are

not to be mixed. Only batteries of the same or equivalent type as recommended are to be

n'est

used. Batteries are to be inserted with the correct polarity. Exhausted batteries are to be

removed from the product. The supply terminals are not to be short circuited. Do not throw

batteries into a fire. Remove the batteries if you are not going to use the

product for a long period of time. Battery shall not be exposed to excessive heat such as

sunshine, fire or the like.

WARNING: Malfunction or loss of memory may be caused by strong frequency

interference or electrostatic discharge. Should any abnormal function occur,

remove the batteries and insert them again.

RP510AVIM1467_325_V03.idml 7

alarm

press on UP or DOWN to change the volume.

volume down.

volume up.