Dometic HIPRO ALPHA Serie Instrucciones De Uso página 18

Troubleshooting
Fault
Poor cooling perfor-
mance
Frost formation in the
minibar compartment
Interior lighting not
working
18
Possible cause
Cooling unit not sufficiently ventilated ➤ Provide sufficient ven-
Minibar exposed to direct sunlight
Door of minibar not closed with a
tight seal
Minibar recently filled
For versions with absorber cool-
ing: The input voltage is too low or
high.
Door of minibar not closed with a
tight seal
Power plug not plugged in
Interior lighting is defective
Surface of infrared door sensor is cov-
ered by condensate water
HiPro
Solution
tilation, see Installa-
tion Manual
➤ Take minibar out of
direct sunlight
➤ Check distances, see
Installation Manual
➤ Contact service
agent.
➤ Service agent:
Replace door seal
➤ Check cooling again
after 5 to 6 hours
➤ Check input voltage
➤ Check distances, see
Installation Manual
➤ Contact service
agent.
➤ Service agent:
Replace door seal
➤ Insert power plug into
socket
➤ Contact service
agent.
➤ Service agent:
Change interior light-
ing
➤ Clean the surface of
the infrared door sen-
sor
EN