Assembly And Adjustment - DeWalt DC305 Manual Del Usuario

All manuals and user guides at all-guides.com
E N G L I S H
below. If you are in doubt, contact an authorized
D WALT repair agent or a qualifi ed electrician.
E
● Disconnect the plug from the supply.
● Cut off the plug and dispose of it safely; a plug
with bared copper conductors is dangerous if
engaged in a live socket outlet.
● Only fi t 13 Amperes BS1363A approved plugs
fi tted with the correctly rated fuse (1).
● The cable wire colours, or a letter, will be
marked at the connection points of most
good quality plugs. Attach the wires to their
respective points in the plug (see below). Brown
is for Live (L) (2) and Blue is for Neutral (N) (4).
● Before replacing the top cover of the mains plug
ensure that the cable restraint (3) is holding the
outer sheath of the cable fi rmly and that the two
leads are correctly fi xed at the terminal screws.
4
3
WARNING: Never use a light socket.
Never connect the live (L) or neutral (N)
wires to the earth pin marked E or
Using an extension cable
An extension cord should not be used unless
absolutely necessary. Use an approved extension
cable suitable for the power input of your charger
(see technical data). The minimum conductor size
is 1 mm ; the maximum length is 30 m.
2

Assembly and adjustment

WARNING: Prior to assembly and
adjustment, always remove the battery
pack.
WARNING: Always switch off the tool
before inserting or removing the battery
pack.
30
WARNING: Use only D
packs and chargers.
Fitting and removing the battery pack (fi g. A)
● To fi t the battery pack (5), line it up with the
receptacle on the tool. Slide the battery pack
into the receptacle and push until the battery
snaps into place.
● To remove the battery pack, push the release
button (6) while at the same time pulling the
battery pack out of the receptacle.
Charging the battery pack (fi g. A, B)
Always check the mains prior to charging the
battery pack. If the mains is functioning but the
battery pack does not charge, take your charger
to an authorized D WALT repair agent. Whilst
E
charging, the charger and the battery pack may
become warm to touch. This is a normal condition
and does not indicate a problem.
1
CAUTION: Do not charge the battery
pack at ambient temperatures < 4 °C
2
or > 40 °C. Recommended charging
temperature: approx. 24 °C.
● To charge the battery pack (5), insert it into the
charger (7) as shown and plug in the charger.
Be sure that the battery pack is fully seated in
the charger. The red charging indicators (8)
will blink according to the state of charge of the
.
battery pack.
● When fi nished charging, the indicators are
all on. The charger automatically switches to
equalise mode.
● The battery pack can be removed at any time or
left in the connected charger indefi nitely.
● The red charging indicators fl ash rapidly to
indicate a charging problem. Reinsert the
battery pack or try a new one. If the new pack
also refuses to charge, have your charger
tested by an authorized D
● The red charging indicators fl ash rapidly with
one short blink followed by a long blink to
indicate a problem with the charger. Return the
charger to an authorized D
● When plugged into power sources such
as generators or sources that convert DC
WALT battery
E
WALT repair agent.
E
WALT repair agent.
E