GYS EASYMIG 85 Manual De Instrucciones página 15

TROUBLESHOOTING
OPERATIONAL ISSUES
The flow rate of the welding wire is not
constant.
The unwinding mechanism is not wor-
king.
Incorrect unwinding of the wire.
No welding current.
The wire gets jammed after passing
through the rollers.
The weld bead is porous.
WARRANTY
The warranty covers faulty workmanship for 2 years from the date of purchase (parts and labour).
The warranty does not cover:
• Transit damage.
• Normal wear of parts (eg. : cables, clamps, etc..).
• Damages due to misuse (power supply error, dropping of equipment, disassembling).
• Environment related failures (pollution, rust, dust).
In case of failure, return the unit to your distributor together with:
- The proof of purchase (receipt etc ...)
- A description of the fault reported.
EASYMIG 85
POSSIBLE CAUSES
Spatter is obstructing the opening.
The wire is slipping on the rollers.
The spool's brake or roller is too tight.
Power supply problem.
Dirty or damaged wire-guide sheath.
Pressure roller not tight enough.
Spool's brake is too tight.
Incorrect mains outlet connection.
Poor earth connection.
Power switch not working.
Compressed wire-guide sheath.
Wire blockage in the torch.
No capillary tube.
Wire speed too high.
Air circulation or wind influence.
Gas nozzle is too clogged.
Bad wire quality.
Poor quality of the welding surface
(rust, etc.).
SOLUTIONS
Clean or replace the contact tube and re-ap-
ply the anti-sticking agent (ref. 041806).
• Check the rollers' pressure or replace
them.
• Wire diameter does not match that of the
roller.
• Wire-guide sheath in the torch not suitable
for use.
Release the brake and the rollers.
Check that the start button is in the ON
position.
Clean or replace.
Further tighten the roller.
Release the brake.
Check the socket's connection and verify
that the socket is supplied with 230 V (1PH).
Check the earth wire (the condition of the
clamp).
Check the torch's trigger.
Check the wire-guide sheath and body of
the torch.
Replace or clean.
Check that the capillary tube is present.
Reduce the wire speed.
Avoid draughts and protect the welding
area.
Clean or replace the gas nozzle.
Use a wire suitable for NO GAS welding
Clean the part before welding.
EN
15