idrania XPERT Manual De Instalación Y Mantenimiento General página 10

PROBLEM
Water leakage.
After the filter has
started up, there is
no flow in the return
nozzle.
Intermittent operation.
The flow rate of the
filter is low.
Water comes out
through the mouth of
the filter.
The filter valve leaks
through the drain
terminal (DRAINAGE).
The motor does not
start up. It makes no
noise or vibration.
The motor does not
start but a buzzing
sound can be heard.
10
CAUSE
Check the reason for water loss.
The valve is not in the "filter" setting.
The filter is above the level of the
water and is unprimed.
The suction cover or the skimmer
plug has been inserted.
Low water level in skimmer
The filter is not primed.
Due to use, the filter is dirty.
The filter is not primed.
The connection between the valve
and the filter is dirty.
The metal band is loose.
Damage of inner coupling due to
incorrect use of chemical products.
Valve head broken due to incorrect
use (over-tightening).
There is no current in the power line.
Problem with the motor.
SOLUTION
Ensure that the clamps and
terminals are in the correct position
and have been tightened.
If the water loss continues, contact
the pool manufacturer's after-sales
service.
Disconnect the filter and put the
valve in the correct setting.
Place the filter in the correct position
and prime it.
Remove the suction cover or the
skimmer plug.
Fill the pool and prime the filter.
Prime the filter.
Perform a backwash.
Prime the filter.
Clean the sand from the opening.
Insert the coupling on the valve
properly and tighten the metal band
firmly.
Change the top valve cover.
Do not put chemical products in the
prefilter skimmer basket.
Change the valve head; do not
over-tighten.
Make sure that there is current
running in the power line.
Please contact the vendor.
Installation and General Maintenance Manual - MONOBLOCK FILTER