Monoblock Filter; Installation And General Maintenance Manual - idrania XPERT Manual De Instalación Y Mantenimiento General

MONOBLOCK FILTER INSTRUCTIONS
The manual can be downloaded as a PDF file from the website: www.astralpool.com
Read this manual carefully and keep it in a safe place for future reference.
This manual covers the filtration unit that is described (name and reference) in the atta-
ched document "TECHNICAL CARACTERISTICS".
• All electrical installations should comply with the following standard:
EN 60335-2-41, safety of household or similar electrical appliances,
The installation must therefore comply with all rules pertaining to "the construction of electrical insta-
llations within specific confines: swimming pools and fountains", or the equivalent standard in force in
each region or country.
• The electrical installation should be done by someone qualified in working with electrical equip-
ment. This unit is not designed for anyone with a physical, sensory or mental handicap or people
lacking in experience, unless done under supervision or with instructions of use from a person in
charge of safety.
• The height of the sand should not exceed 2/3 of the height of the tank.
• It is important to check that the suction ports are not blocked.
• Check the level of dirt in the filter regularly.
• The unit must not be switched on while the pool is being used.
• Do not operate the unit unless it is properly primed.
• NEVER touch the filter when it is operating if you are wet or have wet hands.
• When handling the filter or valve, DISCONNECT the power supply.
• Make sure that the ground is dry before touching the electrical equipment.
• Do not submerge the or put it in a place where it could be submerged.
• Do not permit children or adults to sit or lean on the unit. Children should be supervised to ensure
that they do not play with the unit.
• If the power cord is damaged, it must be replaced by the manufacturer or an approved service engi-
neer or a similarly qualified person in order to avoid hazards.
• It is essential that any damaged component or set of component is changed as soon as possible. Only
use parts that are approved by the sales representative.
• The unit should be connected to a power supply (see data on the pump' s plate), with an earth
connection, protected by a residual current device (RCD) with a rated residual operating current
that does not exceed 30 mA. or by an insulating transformer.
• Forbid access to the pool if any damage of the filtration system(s) occurs.
• Whenever chemical products are used to treat the pool water, it is recommended that the minimum
filtration time is respected in order to protect bathers' health, as stated by the health regulations.

Installation and General Maintenance Manual

European Low Voltage Directive 2014/35/CE.
particular requirements for pumps.

- MONOBLOCK FILTER

3