idrania XPERT Manual De Instalación Y Mantenimiento General página 8

• Stop the unit, put it in the desired filter position and remove the hose from the waste position, if you so
desire.
4.4. DRAINING THE POOL
The filter allows you to drain most of the pool water after the bathing season has ended. In order to
do so, you should set the top selector valve on the drainage setting without plugging in the filter and
connect a hose to the valve waste outlet and direct the other end to the drain or sewer.
THE HOSE SHOULD NOT CONTINUE TO APPLY SUCTION TO THE BOTTOM OF THE POOL LINER.
THE PUMP MAY BE SERIOUSLY DAMAGED IF IT OPERATES WITHOUT WATER CIRCULATION
OR MAY DAMAGE THE LINER.
4.5. RINSING
Having completed a filter "BACKWASH" cycle and having put the unit on "FILTER", mode for a few seconds, the
water flowing into the pool will be cloudy. To avoid having cloudy water running into the pool, use the "RINSE"
setting.
This works as follows: immediately after "BACKWASHING", stop the pump, turn the valve to "RINSE" and
connect the pump again for one minute, then stop the pump and turn the valve to "FILTER".
4.6. RECIRCULATION (ONLY PERFORMED BY A 6-WAY VALVE)
With the valve in this position, the water goes directly from the pump to the pool, without passing through
the filter.
4.7. CLOSED
The "CLOSED" position for the selector valve is used to prevent water from circulating through the hoses and
the filter.
5. CABLE REPLACEMENT
If the power cable becomes damaged, it must be replaced by the manufacturer, your after-sales service en-
gineer or a similarly qualified person in order to avoid hazards.
8 Installation and General Maintenance Manual - MONOBLOCK FILTER