Packaging Components; Requirements For Proper Installation - idrania XPERT Manual De Instalación Y Mantenimiento General

1. PACKAGING COMPONENTS

This unit is designed for above-ground pools.
Units
1 Base
1 Blow-molded filter housing
1 Pump
1 Valve
1 Set of straps
1 Pressure gage
1 A Ø38 mm valve-pump connection hose (metal clamps included)

REQUIREMENTS FOR PROPER INSTALLATION

This unit can be assembled by an adult in 2 hours. Follow the instructions in this manual step-by-step.
Before installation, have the following tools close at hand:
PROCESS
Tightening the hose flanges
Tightening the pump' s screws
Collector pipe protection
*Some models include funnel
2. BEFORE CONNECTING THE FILTER
2.1. LOCATION
Place the filter on a flat, solid surface at a minimum distance of 3.5 meters from the pool (in accordance with
standard installation regulations of electrical appliances in swimming pools in force in each region or coun-
try) at the same level as the bottom of the pool to prevent air from entering the cleaning circuit and to ensure
that the filter remains primed. The filter should be protected from the sun and rain, and kept in a sufficiently
ventilated area during operation. Never cover it during operation.
Installation should be carried out using hoses of a maximum length of 4.5 meters that enable the filter unit
to be placed on a flat, solid surface at least 3.5 meters away from the pool. Should the hoses be too short,
contact your service engineer.
It is important to check that the suction ports are not blocked.
During the installation process, if in doubt, contact the vendor of the unit.
4
COMPONENTS
7 mm Stecker/Phillips screwdriver
13-mm wrench
Piece of plastic*
Installation and General Maintenance Manual
TOOLS
- MONOBLOCK FILTER