Wall Climbing (Surface Control System™); Stopping The Cleaner And Removing From The Pool - Polaris NEO EM27 Manual Del Propietário

Page 8
4.4 Wall Climbing (Surface Control
System™)
The cleaner has the ability to clean the pool walls up to
the waterline. How much the cleaner needs to grip to the
wall depends upon the pool surface.
Grip Intensity Indicator:
Surface Control System (SCS) settings are as follows
for diff erent pool surface types:
1 Pebble Surface (ROUGH)
2 Concrete
3 Vinyl / Fiberglass
4 Tile (SMOOTH)
Check Wall Climbing Setting:
• Start the cleaner and watch as the cleaner climbs
each wall. If grip setting is correct, the cleaner will
easily climb the wall and clean up to the waterline.
The default setting is
NOTE: Wall climbing is programmed in a randomized
pattern. Cleaner may climb wall and not reach
waterline until third or fourth attempt in order to
thoroughly clean wall surface below the waterline
first.
• Adjust the wall climbing setting as necessary using
the following guidelines:
INCREASE: if cleaner is climbing the wall slowly and
stays below the waterline.
DECREASE: if cleaner is climbing the wall too quickly
and sucking air at the waterline.
Adjust SCS Wall Climbing Setting:
You can change the wall climbing setting at any time
during cleaner operation with the SCS button. The
new setting will be active when the cleaner climbs the
next wall.
• Press to adjust the wall climbing setting one
level higher.
• One additional LED lights each time you press the
button to indicate stronger grip on the wall.
• To decrease setting, press button to cycle through
back to one LED (lowest setting).
_
1
2
3
+
4
1 Pebble Surface (ROUGH)
2 Concrete
3 Vinyl / Fiberglass
4 Tile (SMOOTH)
_
1
2
3
+
4
4.5 Stopping the Cleaner and Removing
from the Pool
1. If the cleaner is still in operation, press
to interrupt operation. If cleaning cycle is
complete, begin at Step 2.
2. When the cleaner is within arm's reach, pull
gently on the fl oating cable to bring the cleaner
handle within arm's reach.
3. Use the handle to lift the cleaner from the water
and hold the cleaner vertically over the pool
surface to drain.
NOTE: Never lift the cleaner out of the pool by the floating
cable.
1
Figure 6. Lift Cleaner from Pool with Handle, then
Drain Out the Water
2
3